Perfect Fit for Your Device
Why custom connectors and cable lengths matter more than you think
A power adapter that fits electrically is not enough. It must also fit mechanically — into your device's enclosure, your assembly line's workflow, and your end customer's operating environment.
Most buyers focus on voltage, current, and efficiency specs when selecting a power supply. Those are important. But there's another dimension that gets overlooked until the moment a production line stops because the connector doesn't match the receptacle, or the cable is 5 cm too short to reach the terminal block inside the enclosure.
The wrong cable length can stop your production line. The right one makes assembly effortless.

What we hear from customers every week
These are not rare edge cases. They come in as routine requirements from engineers and procurement teams who know exactly what they need.
Output cable: ±1 cm tolerance Connector: JST XH series Connector: Molex Micro-Fit 3.0 Integrated: Ferrite core on cable Add-on: In-line fuse holder Indicator: LED on output cable
Each of these requests comes from a real operational constraint. Let's unpack why they matter.
Why these details drive real value
These are not cosmetic preferences. They are functional requirements driven by three factors:
Production line automation — A robot arm picks up the adapter and inserts the connector into the device. If the cable is 3 cm longer than specified, the excess length creates a loop that the gripper cannot manage. If it's 2 cm shorter, the connector doesn't reach the mating half. The line stops. Output drops.
Space constraints inside the enclosure — Modern devices pack more functionality into smaller volumes. There is no room for coiled excess cable. The cable path is pre-designed. Every millimeter counts.
Field service and maintenance conditions — In industrial environments, cables are pulled, twisted, and exposed to vibration. A standard connector that works in a lab may fail after six months on a factory floor. Specific JST or Molex models are chosen because they have proven retention force and environmental sealing for that application.
Our capability: an in-house wire harness workshop
Most power supply manufacturers outsource their cable assemblies. That introduces coordination overhead, tolerance stacking between suppliers, and limited control over quality. KRECO operates its own wire harness workshop. This gives us direct control over every aspect of the cable assembly — from wire stripping length to crimp height to final assembly inspection.
Precise cut length Wire cut to ±1 mm accuracy
Custom connector termination JST, Molex, AMP, custom models
Multi-gauge support AWG 18 to AWG 28 available
Beyond basic wiring: integrated components
Sometimes the cable is not just a cable. It becomes a functional extension of the power supply itself. Our workshop integrates additional components directly onto the cable assembly — eliminating separate mounting steps for your production team.
Ferrite core EMI suppression on the cable
Fuse holder Overcurrent protection inline
LED indicator Visual power status on cable
Each integrated component is mounted, soldered, and strain-relieved within our workshop — not as a separate subassembly that arrives loose in the box. This reduces your incoming inspection workload and eliminates a potential point of failure on your assembly line.
Quality validation: tested before shipment
A custom cable assembly is only as good as the testing that validates it. Every custom part we produce goes through two mandatory tests before leaving our facility.
Two tests, every custom part, every time
Insertion life test Simulates repeated connect/disconnect cycles to verify contact retention and wear resistance. Typical spec: 5,000+ cycles without degradation.
Pull force test Measures the force required to separate the connector from the cable. Validates crimp quality and strain relief effectiveness. Typical spec: exceeds cable tensile rating.
These tests catch defects that would otherwise appear in the field — intermittent connections, loose terminals, broken conductors. By validating at the component level, we eliminate failure modes before they reach your production line or your end customer.
We make power supplies that fit your device — not just electrically, but physically, mechanically, and operationally.
Electrically Mechanically Operationally
Perfect fit for your device — from the connector to the last centimeter of cable.